custom leads

When ordering your 9 volt power supply with custom 9 volt pedal cable, please supply the following information.

OPERATING VOLTAGE Specify the input voltage for your country e.g. 115volts, 240volts, other.

The Sherlock Amplifiers power supply has three 9VDC outputs on it, and comes with a 1 meter (2.1mm ends) lead as standard. Usually, to connect all the pedals together you will use the cable supplied with most common brand pedals, assuming you were given one? Alternatively, if you like we can provide you with a custom cable with any type of plug on it. The plugs can be at equal intervals along the cable or we can hand make the cable with the plugs where you want them, within reason of course. The plugs we use for most applications are low profile right angle types. (see below)

Cable prices are determined by the number of plugs and are $6 Australian (approximately $3 US) per plug - including wire and labor to hand solder and quality test each cable)

CABLE DETAILS	COMMENTS
1. Specify NUMBER of plugs.	Including plug to connect to power supply
2. Specify PLUG HOLE SIZE.	2.1mm, 2.5mm, other. (size of hole in plug) (i.e. 2.1mm hole diameter std. for most popular pedals)
3. Specify BARREL LENTH	Contact barrel lenth, long or short (short std.)
4. Specify TYPE of plug.	DC connector, (as detailed above) 1/8 jack plug, etc, straigh or right-angle.
5. Specify DISTANCE	from plug to plug.
6. CABLE PRICE	$AU6 per any connector

NOTE: When custom designing your cables it's best to lay your pedals out on your pedal board the way you have decided to use them. Measure the distance from one socket to the next socket with the pedals on the board in the correct configuration, make sure you write down your socket to socket measurements or draw a picture with the dimentions on it. Next, allow some slack for the cable to go down to the pedal board and back up to the pedal socket and once again record your measurement. Also have the signal leads plugged in to see if the cable plugs are not going get in the way of anything. Once you have worked out your cable measurements we would like to hear from you. We believe that right angle plugs are best because of there low profile, but you may not be able to use a right angle in some situations that's perfectly ok, we can offer a solution for any situation.

Shipping costs will depend on where you are. We will quote on shipping when we receive your order.


	9 VOLT POWER SUPPLY ORDER DETAILS and CUSTOM PEDAL POWER CABLES

		Back